Site Planner

parking & charging layout on real-world imagery
Site planner Power Cables Costs Overview NEN 1010
Site

Site plans 0

Kept in this browser only. Export a plan to move it to another machine or a colleague; an import always comes in as a new plan.

Background

Go to
Draw

Parking bays

Bay style

Remembered in this browser only; not saved in the plan file.

Equipment

Pick a type, then click the map to place it.

Cabling

Click a transformer, cabinet or charger to start, click to add corners, then click the far end to finish. shift locks a leg to 45°, enter ends it loose, backspace takes back a corner.
Select it, then ctrl+drag the line to add a corner and alt+click a corner to take it out — the same two on routes, cables and trenches. Drag a white handle to move a corner or a loose end; drag a loose end onto a box to attach it. An attached end is a ring — it lives where its box lives, so move the box, or alt+click the ring to break it off.

Cable

—

Product

—

Installation

—

Load

Enter a load to get a voltage drop.

Sizing

—
Size this run in NEN 1010 →
The calculator opens with this run already picked. Send the result back from there and it lands on this panel.

Trenches

A trench is dug once and carries several circuits — so it is costed once, and how many cables share it is the grouping figure a sizing calculation needs. Draw it, then assign runs into it from the Cable panel.
It snaps to equipment at either end but need not start on any. Click the last point again or press enter to finish; shift locks a leg to 45°. Select it afterwards to drag its corners and ends, exactly as for a cable.
Widths and depths are common-practice starting points, not a standard — your network operator’s directive sets the real ones.

Trench

—

Section

—

What is in it

—

Routes

Click to lay out the route, then click the last point again or press enter to finish. shift locks a leg to 45°, backspace takes back a point.
Widths are common-practice starting points, not a standard — set the real one per route.

Route

—

Truck run

—
0.0 s

Join end to end

A route cannot be extended once it is drawn, so a long run laid out in two sittings stays two objects. This makes it one, joining whichever pair of ends is nearest. A route has one dock — if both have one, a bay beats a plain waypoint, and anything given up is named.
Click a waypoint to pick it, then del — or alt+click it in one go. ctrl+drag the line adds a waypoint where you grab it. A bay counts as one stop: deleting either of its ends takes the route back out of the bay, and no corner can go between them.
Edit

Selection 0

Power

—

Array / repeat


Raise Count or Rows to preview the copies on the map; nothing is previewed while this panel is closed.
For slewed / echelon rows: rotate one bay to 45°, set direction to Custom bearing along the kerb line, and leave auto pitch on.

Tools

Plan

Plan

Open cost report →
Reference

Keys

  • click select · shift+click add
  • ctrl+drag rubber-band select
  • arrows nudge · +shift ×10
  • R/shift+R rotate 15°
  • ctrl+D duplicate · del delete
  • ctrl+drag a line to add a corner
  • alt+click a corner to remove it
  • drag a white handle to move a corner or loose end
  • alt+click a ring to detach that end
  • ctrl+Z/ctrl+Y undo/redo
  • esc cancel